RepaCoat PH
Wear Resistant Coatings

RepaCoat PH is a highly filled 2-component polymer material with high grade ceramic filler and special high-density ceramic spheres for exceptional wear resistance.

RepaCoat PH is primarily used to protect materials that are exposed to extreme wear by hard particles in a gas, liquid or hard media. It is also effective against lateral impacts, and is an excellent replacement for ceramic tiles. It has excellent leveling properties.

Properties

  • Excellent wear resistance under high-load conditions
  • Filled with high grade ceramic fillers and ceramic spheres
  • Paste-like consistency; will not drip
  • Coating thickness up to 1 cm (.393 in.) per layer
  • Finer grades are both tough and elastic.
  • Excellent adhesion on all metallic surfaces

Typical Applications

  • Ideal as a new coating or to restore machine functionality
  • Extruders, ventilators
  • Tubes, especially down pipes, chutes
  • Containers for loose goods
  • Exhaust systems - see chart for temperature limit
  • Centrifuges and cyclones
  • Transport systems, including screw conveyors
  • Mixers
  • Pumps

Package Sizes

  • 100g, 250g, 500g, 1.000g (3.52 oz, 8.81 oz, 17.63 oz and 2.20 lbs.)
  • Larger packages on request

Technical Data:

  • Thermal Resistance:
  • Continuously at 150°C, (302°F) peak 200°C (392°F)
  • Pot Life at 5°C: (41°F) approx. 3 hours
  • Cure Time: 24 hours (full load at 48 hours)
  • Shelf Life: 12 months

 

These are average values and may vary, depending on volumes and ambient conditions.

 


Pumps

Pipes & Chutes


Screw Conveyors