MM 1018

Multimetal Steel 1018 eases the installation and adjustment of new bridge bearings for new installations as well as for replacements.

closes gaps from nearly 0 to 15 mm (6")
high permissible pressure
vibration dampening
easily applicable in place
corrosion resistant, non conductive
temperature resistant -40°C/+90°C (-40/+194°F)

MM1018 is applicable for bridges of any kind. It is resistant to weathering and ageing. Trust Multimetal 1018 to repair/maintain bridge bearings.

MM1018 is easily applied in the required coating thickness onto the anchor- or taper-/wedge-plates.

On installation of the coated plates, MM1018 is distributed evenly in all directions, the excess material is squeezed out laterally and can be taken off by spatula.

A 100% gap leveling is achieved without machining! Anchor- and taper-/wedge-plates are adjusted at the same time. MM1018 has a very high compressive strength after full cure and chemical long term resistance.

For more information regarding MM1018, please click here.

A Veteran Owned Company